Sakura Fab: 1UZFE Heat Screen Intake Manifold Gasket set

If you're an automotive related shop (apparel, automotive parts or service) be it big or small this is the place to "shop" your wares.

For a dedicated section of your own please contact the Admin Team for further information.

Moderators: dr.occa, CBR_TOY

Post Reply
dr.occa
Hades - Site Admin
Posts: 7733
Joined: Tue Sep 04, 2007 1:49 pm
Location: On my hiney...in HOU
Contact:

Sakura Fab: 1UZFE Heat Screen Intake Manifold Gasket set

Post by dr.occa »

A 4C/7.2F-10C/18F degree change in air temperature (increase or decrease) will cause a 1-3% horsepower change. These gaskets will lower the temperature of the intake manifold by at least 11C/20F and benefit both naturally aspirated & forced induction environments.

Image


Test Vehicle information
*The following conditions were consistent in both before and after states in collecting the proceeding data.
Engine: 1.6 (naturally aspirated w/ 278 in/ex cams) small port
State: 1100RPM idle
Coolant temp: 76C/168F
Vaccum: 10 in.hg
Ambient temp: 11C/52F

w/ Stock Intake Manifold Gasket (temperature reader held at ~24")
Image

w/ Heat Screen Gasket (temperature reader held at ~24")
Image
**Temperature readings were taken from approximately the same location on the no. 1 cylinder intake runner.

$40USD + $7USD shipping to lower 48 states / $10USD to CAN

Heat Screen Washers are available for an additional $5USD for a set of 9. Shipping separately is $3USD.

All orders are shipped with tracking.

Don't forget to specify if it's for either a large port or small port when ordering the Heat Shield gasket.

For international sales, please send an email with your shipping information.

PayPal:
Image

Post Reply