Sakura Fab: 4AG Heat Screen Intake Manifold Gasket

[dr.occa]

A 4C/7.2F-10C/18F degree change in air temperature (increase or decrease) will cause a 1-3% horsepower change. These gaskets will lower the temperature of the intake manifold by at least 11C/20F and benefit both naturally aspirated & forced induction environments.


(heat screen washers are not included but are available for an additional $5.00 for a set of 9)


smallport gasket:




largeport gasket:




Test Vehicle information
*The following conditions were consistent in both before and after states in collecting the proceeding data.
Engine: 1.6 (naturally aspirated w/ 278 in/ex cams) small port
State: 1100RPM idle
Coolant temp: 76C/168F
Vaccum: 10 in.hg
Ambient temp: 11C/52F

w/ Stock Intake Manifold Gasket (temperature reader held at ~24")


w/ Heat Screen Gasket (temperature reader held at ~24")

**Temperature readings were taken from approximately the same location on the no. 1 cylinder intake runner.

Discontinued Until Further Notice

[86boy]

hmmmm small port GZE might need this. I was seeing 165* F intake temps just puttin around town. @dr.occa This basically replaces the intake manifold gasket correct?

[dr.occa]

hmmmm small port GZE might need this. I was seeing 165* F intake temps just puttin around town. @dr.occa This basically replaces the intake manifold gasket correct?

[86boy]

Once I get settled in and such. I'll have to pick this up! I've been looking at em for a while.

[dr.occa]

Yes, you buy.