ECU Pinouts for Water Temp Sensor

[c4ptiv3]

finally ready to start finalize the new engine, however, the wiring harness I have doesn't have the water temperature system wires and plug. Mckenney was kind enough to give me that part of the harness but I do not know which pin outs on the ECU plug they plug into, can anyone help me out here?

[McKenney]

I'll shoot you a pic in a few... Just got home

Sent from my LG-MS690 using Tapatalk

[dr.occa]

Old man McKenney still hasn't posted the ecu pinout for you? Man, he's probably looking for his walker.

Here ya go (compliments of Club4AG's reference section):

THW is your water temp.

[McKenney]

ouch, was going to take a pic of the actual ecu and said wires. a.d.d. kicked in and I forgot. Sorry Jeremy

[dr.occa]

You know I'm just ribbing ya

[c4ptiv3]

not a problem McKenney and thank you guys! I have one more question. The sensor has 2 wires but that is only showing one plug, do both wires hook up and if so does it matter which one goes on top or bottom?

That wasn't a very good explaining of the question and I'm not sure how else to word it.

[dr.occa]

The 2nd should connect to a communal ecu ground IIRC.

[dr.occa]

Tap the brown wire to either E21 or E2. The green goes to THW on the ECU.

[c4ptiv3]

awesome, thank you!