Page 1 of 2
my BT 20v
Posted: Fri Jul 10, 2009 8:24 pm
by mandm177
Posted: Fri Jul 10, 2009 9:00 pm
by ga_goosh
nice lookin good how long did it take you to get where you are?
Posted: Fri Jul 10, 2009 10:24 pm
by mandm177
about 4 months...there was lots of waiting for things to come in, and LOTS of waiting on my friend to weld or drill and tap holes.
i wanted it to be done in a month, but what can you do?
Posted: Sat Jul 11, 2009 9:13 am
by joel26
Nice love the throttle sound.....
Posted: Wed Jul 29, 2009 8:50 pm
by CBR_TOY
i can't wait to get mine done... did you get the dizzy cap from performanceoptions.com?
Posted: Thu Jul 30, 2009 8:45 am
by mandm177
Yep. when i ordered mine, they warned me that 1 of the holes was slightly off, and that i had to enlarge it a tiny bit. Not sure if they have fixed that problem since though. Its something id ask about if you decide to get it.
I put it on with 2 out of the 3 bolts, and its on there pretty solid. i wouldnt let that effect your decision.
Posted: Thu Jul 30, 2009 8:51 am
by CBR_TOY
oh ok thanks for the info.... i might just end up making my own. how was wiring on your setup?
difficult?
Posted: Thu Jul 30, 2009 12:05 pm
by mandm177
i was lazy with the wiring and had Dr. Tweak do it :D. i could have probably done it, but it wouldnt have been as clean.
Posted: Wed Sep 09, 2009 2:35 pm
by coupesprinter
Great looking setup! Sounds good too. :D
Posted: Wed Sep 09, 2009 3:01 pm
by CBR_TOY
did you do the 16v water pump
Posted: Thu Sep 10, 2009 9:31 am
by mandm177
yessir. i bought the water relocation kit from Sam_Q on the club4ag boards.
Used a new 16v water pump from the dealer, but you have to grind down the front case a bit so that it'll clear the timing belt tensioner pulley.
Posted: Thu Sep 10, 2009 9:52 am
by CBR_TOY
got any pics of this install....
Posted: Thu Sep 10, 2009 10:29 am
by mandm177
CBR_TOY wrote:got any pics of this install....
unfortunately i do not...if you get the water pump, you'll immediately know how much and where you have to grind. just dont do it too much.
as for the water relcation kit...Sam_Q on club4ag has a link that shows his work, but i just dont know what it is...he's in australia, so if you PM him, he usually responds later that night.
Posted: Thu Sep 10, 2009 10:48 am
by CBR_TOY
is it the one where you just weld the 90 onto the pipe and it's the upper hose?
i've seen a thread about this on club4a
Posted: Thu Sep 10, 2009 11:27 am
by mandm177
yep, thats the one.
he actually has a new adapter coming out that allows you to use the stock 16v upper water neck so you dont have to cut/weld anything.
