gts clutch hardline

[daveskatesallday]

does anyone know how the gts clutch hardline is run through the engine bay??
on the motor i just pulled out of my car it had a sr5 bellhousing with the clutch hardline on the driver side but the gts bellhousing re-locates the slave cylinder to the passenger side and someone shipped me a gts clutch hard line but i can't find pictures of how it's run through the engine bay like if it goes behind the brake booster or what i know its not rocket science but i just want to make sure i bend it in all the right places so theres no issues if anyone knows or has pictures that would be a huge help thanks

[mooreofit]

if you go to my build thread you might see it run on the firewall.

[daveskatesallday]

i checked i can't get a good picture of it most of the pics are blurry and the clear ones i can't get a good enough look i can't tell which one it is

[mooreofit]

theres one picture on page 4 that gives you a good idea of where it goes and one on page 5. i forget witch line it is i can figure it out real quick and let you know.

[daveskatesallday]

Cool lemme know

[assassin10000]

I have a great pic of it from my GTSR5 swap thread...



Andrew

[daveskatesallday]

thanks you are a life saver without the pic i was kinda on the right track but i would have been off more towards the passenger side haha i wasn't sure if it ran right behind the brake booster or in the middle behind it but this is exactly what i needed

[dr.occa]

Of course Andrew would have a great illustration. Doh!

[daveskatesallday]

thanks for the most part the person who shipped it to me had to bend the line a little to get it in a container to ship to me so i had to bend it back its not too bad but not that clean as in your picture

also couldn't find a bolt to mount the bracket to the side so i just kinda left it free @_@