7-rib, red top built 4A-GE

Moderators: dr.occa, CBR_TOY

Post Reply
mr2rudy
Tourist
Posts: 29
Joined: Sun Oct 02, 2011 2:20 pm

7-rib, red top built 4A-GE

Post by mr2rudy »

Built back to factory specs 4A-GE out of 1988.

Has timing belt, oil pump, water pump. Ready to go

This is the rarer 7rib red top not 3rib blue top.

$600.

972-762-1570

Please contact only if you have cash ready and are serious about purchasing. Thanks

Motor in north Dallas. Local pickup only please

McKenney
VIP Member
Posts: 2244
Joined: Tue Feb 09, 2010 10:59 pm
Location: Richardson, TX

Re: 7-rib, red top built 4A-GE

Post by McKenney »

oil squirters? small port head or big port? I've seen 88 mr2s with a 7 rib block, no squirters, big port head with tvis. some of them have 18mm/40mm rods and a few that were 20mm/42mm configuration. these were a weird cross over time for the 4age. verify which one you have. all red tops were small port btw.

McKenney
VIP Member
Posts: 2244
Joined: Tue Feb 09, 2010 10:59 pm
Location: Richardson, TX

Re: 7-rib, red top built 4A-GE

Post by McKenney »

you're in North Dallas, I'm in Richardson, I could come look and tell you exactly which one it is.

mr2rudy
Tourist
Posts: 29
Joined: Sun Oct 02, 2011 2:20 pm

Re: 7-rib, red top built 4A-GE

Post by mr2rudy »

I'm about 85% sure it is the non-oil squirter on bottom of the piston-type but I'm going off of billzillas Australian website. So it could have oil squirters.. It is a factory red- top though that I am sure of (not just red valve covers on a blue top head. It's good to go. Come and get it. It's in the. 75080 on an engine stand. I have pics but even compressed they are too large to upload here. (4mb). Call me for the address. A little worried about posting my address on the internet. Mahalo

User avatar
pecx
Zeus - Ultra Mega Admin
Posts: 1102
Joined: Fri Aug 03, 2007 3:17 am
Location: Houston

Re: 7-rib, red top built 4A-GE

Post by pecx »

I want this small port and I have cash for it but too bad I'm in Houston.

McKenney
VIP Member
Posts: 2244
Joined: Tue Feb 09, 2010 10:59 pm
Location: Richardson, TX

Re: 7-rib, red top built 4A-GE

Post by McKenney »

it is a late 87 88 model motor from an aw11 mr2, 7 rib no squirters, big port, red top mr2 valve covers, dunno if it is one of the 42mm journal motors but it's super clean fresh rebuilt. Rudy lives less than a mile from me lol. never knew! nice meeting you and glws.

McKenney
VIP Member
Posts: 2244
Joined: Tue Feb 09, 2010 10:59 pm
Location: Richardson, TX

Re: 7-rib, red top built 4A-GE

Post by McKenney »

I didn't think to get pictures while I was there, sorry guys. but I can vouch, it is fresh and ready to rock

Post Reply